© Edwards Limited 2017. All rights reserved. Page 101
Edwards and the Edwards logo are trademarks of Edwards Limited.
Digital pressure measurements
M588-08-880 Issue D
8. Route the cable inside the GXS enclosure as shown in Figure 76. Use cable ties to attach the cable to the water
pipes.
Figure 76 - Correct routing of the accessory cable
9. Connect the other end of the cable into the free socket on the end of a cable that itself goes into the GXS
controller as shown in Figure 77.
Figure 77 - Connecting to the control system
10. If there is any excess cable, loop it back on itself and secure it firmly with a cable tie. Ensure that it cannot
come into contact with the pump surfaces.
Figure 78 - Securing excess cable with a cable tie
11. Replace the covers of the GXS system.
To Next Page
Loading...
