Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-50 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
CLR LED
Description: Clears any LED's which have been forced on using the SET LED
command.
Command Level: 5
Syntax: CLR LED [n]
Comments: This command turns off an LED if it has been turned on with the SET LED
command. However, this command will NOT turn off any LED that has been turned on
because of its control program.
Notes: This command could potentially initiate a user report if everything were
programmed correctly. First, the LED in question would have to be configured as an
alarm type. Second, a user would have to be configured to receive a retired alarm report
and he would have to have the LED in question as one of his user channels. Once the
LED is cleared, a user phone report or Email message would occur. Any user entering
this command will have his name and this action recorded in the event log.
Related Commands: SET LED
Example:
Command<5>: CLR LED
Clear LED:
To Next Page
Loading...
Need help?
General
