Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 2-32 Chapter 2. Operating LMS1000
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Downloading and Uploading Using TFTP
System configuration files can be saved on disk, or loaded back into a system using the
DOWNLOAD TFTP and UPLOAD TFTP commands, as described below. These
commands are also described in "Chapter 3. Commands". These commands are
available to users programmed for access to level 6 commands.
To Download the Configuration from the LMS1000 to a PC using TFTP:
1) Start a separate TFTP client session on the host to which the configuration file is
transferred.
2) Log on to the system. The user must have access to level 6 commands.
3) Enter the command DOWNLOAD TFTP, then press ENTER. The following will
be displayed.
DOWNLOAD using TFTP
4) After seeing the above prompt, start the download process from the client. DO
NOT ATTEMP THE DOWNLOAD UNTIL THE PROMPT ABOVE IS
DISPLAYED.
To Upload a Configuration from a PC to the LMS1000 using TFTP:
1) Start a separate TFTP client session on the host from which the configuration file
is transferred.
2) Log on to the system. The user must have access to level 6 commands.
3) Enter the command UPLOAD TFTP, then press ENTER. The following will be
displayed.
UPLOAD using TFTP
4) After seeing the above prompt, start the upload process from the client. DO NOT
ATTEMP THE UPLOAD UNTIL THE PROMPT ABOVE IS DISPLAYED.
To Next Page
Loading...
Need help?
General
