Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-110 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
NODE DELETE
Description: Deletes nodes from the database.
Command Level: 6
Syntax: NODE DELETE [[X]node_number]
NO DE [[X]node_number]
Comments: If no modifier is used when entering the command, the system lists all
nodes by Node#, Name, Spec. Number, Ser.# (serial number), Loc (location), and
Echelon Id #. The system then prompts the user to select a node to delete. You select
the node by entering the Node# from the list. Note that the node numbers for unmapped
nodes (nodes that were not previously configured) are temporarily listed as X01 through
X99 for reference. If a node that was previously configured is deleted, the user may also
delete the node’s channels.
Notes: Use of this command generates an entry in the Event Log. This cancels any
previous node errors. The Main Cabinet, VPS MCA Interface, and LPS MCA Interface
Nodes cannot be deleted, and are not shown in the list.
"IO network is running." is displayed when the network is ready. The follow are displayed
if the network is not ready.
"IO network is adding nodes.
IO network commands not ready!"
Indicates a new IO network is being discovered.
"IO network is verifying nodes.
IO network commands not ready!"
Indicates a known network is being verified.
"IO network is failed.
IO network commands not ready!"
Indicates an IO network has failed and no communication to nodes is possible.
"IO network is not initialized.
IO network commands not ready!"
Only displayed for a very short time after a reset.
"IO network state is undefined!
IO network commands not ready!"
Only displayed for a very short time after a reset on a new system.
Related Commands: NODE ADD, NODE CONFIG, NODE LIST, NODE REPLACE
Example:
Command<6>: NODE DELETE
IO network is running.
Node# Name Spec. Number Ser.# Loc Echelon Id #
01 --- 58212190001 12346 L 1A2B3C4D5F6A
02 --- 58212190001 12346 R 1A2B3C4D5F6B
To Next Page
Loading...
Need help?
General
