User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-187
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET LPS SYSTEM CURLIMIT
Description: Sets the LPS "current limit" value.
Command Level: 6
Syntax: SET LPS SYSTEM CURLIMIT
SE LP SY CU
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA.
Not Changed!
Related Commands: none
Example:
Command<6>: set lps sys cur
Plant Current Limit: 5600 Amps
Plant Current Limit: 5700
New Plant Current Limit Accepted.
To Next Page
Loading...
Need help?
General
