Emerson LMS1000 User Manual

Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-184 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET LPS PASSWORD
Description: Sets the password issued by LMS1000 to gain remote access to the LPS.
This password must match the LPS's MCA remote access password. By default, the
password issued by LMS1000 and set in an LPS is MARCONI!, in all capitol letters.
LMS1000 issues the password set here (or the default if not previously set) when
LMS1000 is initially powered up or during a reset. The LPS does not grant remote
access until the correct password is sent by LMS1000.
Command Level: 6
Syntax: SET LPS PASSWORD
SE LP PA
Comments: The LPS's MCA remote access password is case sensitive, and is limited to
6 characters.
Notes: This command does not change the LPS's MCA remote access password, only
the password issued by the LMS1000 to gain remote access.
Record the new password in a secure place. There is no way to view the password set in
the LMS1000.
Also, if the MCA's remote access password is ever changed, record the new password in
a secure place. The current MCA remote access password cannot be viewed remotely
from LMS1000. The password can be viewed locally, from the MCA's Interface Pad.
Refer to the LPS manual for a procedure.
If LMS1000 does not successfully connect with the LPS during power up or reset, the
following message is displayed when a user attempts LPS access via the LMS1000.
Invalid password
Related Commands: none
Example:
Command<6>: set lps pass
Enter current MCA password:
Enter new password:
Re-enter new password:
New password not accepted
___________________________________________________________________________________
Command<6>: set lps pass
Enter current MCA password:
Enter new password:
Re-enter new password:
New password accepted

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English