User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-269
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET VORTEX SYSTEM NAGTIMER
Description: Sets the VPS "nag minutes" (audible alarm cutoff reset time period) value.
Command Level: 4
Syntax: SET VORTEX SYSTEM NAGTIMER
SE V SY NAG
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA.
Power system did not accept the new value, setting remains
unchanged.
Related Commands: none
Example:
Command<4>: SET V SYSTEM NAGTIMER
NAG (ACO) Timer: 5 minutes
NAG (ACO) Timer:
To Next Page
Loading...
Need help?
General
