User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-139
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
PRCONFIG VORTEX
Description: Displays the current settings and equipment inventory of the VPS.
Command Level: 2
Syntax: PRCONFIG VORTEX, PRCONFIG VORTEX SETTINGS, PRCONFIG
VORTEX INVENTORY
P V, P V S, P V I
Comments: The settings or equipment inventory of the VPS can be viewed separately
by entering the command PRCONFIG V followed by a space and then the specifier
SETTINGS or INVENTORY.
Notes:
Low voltage disconnect settings are only displayed for installed LVDs.
In the event of a PCU failure, the inventory displayed for the failed PCU is as follows.
PCU01-No Reply
PCU02-No Reply
Subsystem shunts are only displayed if a subsystem is installed.
Related Commands: PRCONFIG, PRCONFIG LPS
Example:
Command<2>: PRCONFIG VORTEX
VORTEX POWER SYSTEM SETTINGS AS OF 11:13:06 ON 02/02/01.
Description Value Units
Float Voltage
Test/Equalize Voltage
System High Voltage 1 Alarm
System High Voltage 2 Alarm
System Battery On Discharge
System 50% Battery On Discharge
System High Voltage Shutdown
System Overcurrent
Current limit
System Calibrate Voltage
NAG(ACO) Timer
Temperature Compensation Voltage
Subsystem High Voltage Alarm
Subsystem Low Voltage Alarm
Subsystem Calibrate Voltage
Subsystem Overcurrent
LVD1A Disconnect Voltage
LVD1B Disconnect Voltage
LVD2A Disconnect Voltage
LVD2B Disconnect Voltage
LVD3A Disconnect Voltage
LVD3B Disconnect Voltage
LVD Reconnect Voltage
To Next Page
Loading...
Need help?
General
