User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-169
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET LED
Description: Allows manual energizing, or forcing, of an LED alarm indication.
Command Level: 5
Syntax: SET LED [n]
SE LE [n]
Comments: none
Notes: Any user using the SET LED command will have his name and this action
recorded in the event log. The SET LED command could generate an alarm log entry if
the LED is configured as an alarm type. Additionally, if configured as an alarm type, this
alarm could initiate a phone report or Email message. The LED can be cleared using the
command CLR LED. In an LPS Power System, the name of the LED channel will scroll
across the MCA display when the LED is active.
Related Commands: CLR LED
Example:
Command<5>: SET LED
Set LED (1 - 8): 3
Set LED (1 - 8):
To Next Page
Loading...
Need help?
General
