User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 5. Troubleshooting and Repairing LMS1000 Page 5-15
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Replacing a 586505000/586505500 Expansion Assembly
Note: When performing any step in this procedure which requires removal of existing
hardware, retain all hardware for use in subsequent steps.
Procedure:
1) Observe the admonishments presented at the beginning of this chapter, and in
the previous section titled "REPAIR AND REPLACEMENT INFORMATION".
2) Remove DC input power to the assembly.
3) Connect an approved grounding strap to your wrist. Attach the other end to a
suitable ground.
4) Disconnect all cable connections and remove the assembly.
5) Install the new assembly (make a note of the assembly's neuron identifier
number [written on the assembly]). Reconnect all cables.
6) Remove the grounding wrist strap.
7) Reapply DC input power to the assembly.
8) Log onto the system as a level 6 user.
9) Enter the command NODE REPLACE. Enter the correct information for the node
whose CPU is being replaced and the new node CPU being installed.
To Next Page
Loading...
Need help?
General
