User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 2. Operating LMS1000 Page 2-27
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
USING STATUS PAGES
Sixteen user programmable status pages (or screens) can be formatted in the system.
These status pages can be viewed by any user through the command STATUS. These
pages permit the displaying of scan information (channel status such as present value
and alarm information) derived from separate channels on a single page format. Each
status page can hold up to 18 lines of text. The first line is used for a page title or name,
while the remaining 17 lines are programmed to contain either header information or
actual channel scan data.
SET STATUS Command: The status pages can be created or changed by using the
SET STATUS command. This command is available to users programmed for access to
level 6 commands. This command, when entered, displays a header that contains the
current status pages configuration information. The command then asks which status
page is to be created or changed. Then, individually, the command will list each line,
showing the current information, and then prompting for new or revised information to be
entered. If the current information does not need to be changed, press ENTER to
continue.
To program one of the 17 lines for header information, the user enters the channel type
(e.g. A, B, R, etc.). This will then produce the particular header information as normally
seen during the execution of the standard command SCAN.
To program one of the 17 lines to display actual channel SCAN data, the user enters both
the channel type and number (e.g., A001, B003, R0014, etc).
You can generate a blank line in a status page by pressing the SPACE BAR, and then
ENTER. This will also move you to the next line.
A status page can be programmed with the following characters:
Line 1: Type the page name or title (30 characters maximum).
Lines 2 - 18: Type one of the following characters per line to display Header or
SCAN Information when the command STATUS is executed.
A=Analog Channel Header
B=Binary Channel Header
E=Energy Management Channel Header
F=Function Channel Header
L=LED Channel Header
R=Relay Channel Header
An=Analog Channel n
Bn=Binary Channel n
En=Energy Management Channel n
Fn=Function Channel n
Ln=LED Channel n
Rn=Relay Channel n
Space Bar=Blank line
To Next Page
Loading...
Need help?
General
