Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-188 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET LPS SYSTEM EQMULTIPLIER
Description: Sets the LPS "auto equalize time multiplier" value.
Command Level: 6
Syntax: SET LPS SYSTEM EQMULTIPLIER
SE LP SY EQ
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA.
Not Changed!
Related Commands: none
Example:
Command<6>: set lps sys eq
Auto Equalize Time Multiplier: 0
Auto Equalize Time Multiplier: 1
New Auto Equalize Time Multiplier Accepted.
To Next Page
Loading...
