User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-105
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
NODE
Description: Lists all commands that begin with NODE, and then prompts the user to
enter one of the displayed options.
Command Level: 2
Syntax: NODE
NO
Comments: none
Notes: Only the commands that the user has access to are listed.
"IO network is running." is displayed when the network is ready. The follow are displayed
if the network is not ready.
"IO network is adding nodes.
IO network commands not ready!"
Indicates a new IO network is being discovered.
"IO network is verifying nodes.
IO network commands not ready!"
Indicates a known network is being verified.
"IO network is failed.
IO network commands not ready!"
Indicates an IO network has failed and no communication to nodes is possible.
"IO network is not initialized.
IO network commands not ready!"
Only displayed for a very short time after a reset.
"IO network state is undefined!
IO network commands not ready!"
Only displayed for a very short time after a reset on a new system.
Related Commands: NODE ADD, NODE CONFIG, NODE DELETE, NODE LIST,
NODE REPLACE
Example:
Command<6>: NODE
IO network is running.
Which action?
ADD CONFIG DELETE LIST REPLACE
?