Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-114 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
NODE LIST
Description: Lists information on all nodes in the database.
Command Level: 2
Syntax: NODE LIST [[X]node_number]
NODE LIST [LONG]
NO LI [[X]node_number]
NO LI L
Comments: If no modifier is used when entering the command, all nodes in the
database are listed. The system lists all nodes by Node#, Name, Spec. Number, Ser.#
(serial number), Loc (location), and Echelon Id #. When a node number modifier or the
"LONG" modifier is used; node card information, distribution module information, and
channels are also listed. Note that the node numbers for unmapped nodes (nodes that
were not previously configured) are temporarily listed as X01 through X99 for reference.
Notes: This command does not display any Main Cabinet, VPS MCA Interface, or LPS
MCA Interface Nodes.
"IO network is running." is displayed when the network is ready. The follow are displayed
if the network is not ready.
"IO network is adding nodes.
IO network commands not ready!"
Indicates a new IO network is being discovered.
"IO network is verifying nodes.
IO network commands not ready!"
Indicates a known network is being verified.
"IO network is failed.
IO network commands not ready!"
Indicates an IO network has failed and no communication to nodes is possible.
"IO network is not initialized.
IO network commands not ready!"
Only displayed for a very short time after a reset.
"IO network state is undefined!
IO network commands not ready!"
Only displayed for a very short time after a reset on a new system.
"LPS interface is running" is displayed when the LPS data is initialized.
Otherwise, "LPS interface is initializing!" is displayed.
Related Commands: NODE ADD, NODE CONFIG, NODE DELETE, NODE REPLACE
Example:
Command<6>: node list
IO network is running.
To Next Page
Loading...
Need help?
General
