User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 2. Operating LMS1000 Page 2-31
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
You have up to 1 minute to initiate a file transfer. Each second during this 1
minute period the system sends a 'C' character, which is the synchronization
character for starting an XMODEM CRC file transfer.
3) At the PC, initiate a file transfer using XMODEM CRC protocol.
4) When the transfer is complete, the following is displayed.
84 blocks received OK.
Upload Complete.
The number of blocks received may vary.
Note: If an error message (as shown below) appears, the file being
uploaded must be re-edited to correct the appropriate program line.
The CLR PROG command may be used instead of re-editing the
upload file. Refer to the CLR PROG command in the COMMANDS
Chapter.
202 blocks received OK.
R01=h1
^
Program error -- Bad Character
Upload Complete.