Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-92 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET VORTEX SYSTEM 50APLACES set system number of 50A Places
SET VORTEX SYSTEM 100APLACES set system number of 100A Places
SET VORTEX SYSTEM 200APLACES set system number of 200A Places
SET VORTEX SYSTEM 50%BATONDISCH set system 50% Battery On Discharge alarm
SET VORTEX SYSTEM BATONDISCH set system Battery On Discharge alarm
SET VORTEX SYSTEM CALVOLT set system calibration voltage
SET VORTEX SYSTEM CURLIMIT set system current limit
SET VORTEX SYSTEM FACTORYCAL set system cal. voltage to factory default
SET VORTEX SYSTEM FLTVOLT set system float voltage
SET VORTEX SYSTEM HIVLTALM1 set system High Voltage 1 Alarm
SET VORTEX SYSTEM HIVLTALM2 set system High Voltage 2 Alarm
SET VORTEX SYSTEM HVS set system High Voltage Shutdown
SET VORTEX SYSTEM INVENTORY reset the system equipment inventory
SET VORTEX SYSTEM MODE set Power System mode
SET VORTEX SYSTEM NAGTIMER set system ACO timer
SET VORTEX SYSTEM OVRCURRENT set system Overcurrent alarm
SET VORTEX SYSTEM TEMPCOMP set system Temperature compensation voltage
SET VORTEX SYSTEM TSTEQVOLT set system test/equalize voltage
SET VORTEX SUBSYSTEM CALVOLT set subsystem calibration voltage
SET VORTEX SUBSYSTEM FACTORYCAL set subsystem cal. voltage to factory default
SET VORTEX SUBSYSTEM HIVALM set subsystem High Voltage alarm
SET VORTEX SUBSYSTEM LVALM set subsystem Low Voltage alarm
SET VORTEX SUBSYSTEM OVRCURRENT set subsystem Overcurrent alarm
UPLOAD VORTEX configure Vortex Power System by
uploading file using XMODEM
protocol
where: <> anything enclosed in brackets is optional
n is a valid number
t is A or B for Vortex LVD settings
To Next Page
Loading...
Need help?
General
