Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-216 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
The session timeout feature of the TL1 port operates independently from the system’s
user timeout feature. A session timeout is indicated by transmission of the TL1 CANCEL-
SESSION message.
TL1 Autonomous Messaging:
Address/Phone Number: The PRIMARY PHONE NUMBER attribute of the user's
configuration provides the network address to the system for TL1 autonomous
messages. The DIRECT mode of operation transmits the string stored in the user
PRIMARY PHONE NUMBER attribute prior to transmitting an autonomous message.
This assumes that an existing string in the user PRIMARY PHONE NUMBER
attribute can be detected from a user’s configuration.
Auto-Logoff for Autonomous Messages: Currently, there is no auto-logoff of
users who have established a session via the TL1 port. Pending autonomous
messages are sent after the current user session is ended.
Related Commands: MODE
Example:
TL1/X.25 Software Option Installed
Command<6>: SET MODE
TL1 Mode: Direct
TL1/X.25 Comm Port Setting: 9600, n, 8, 1
Session Timeout: 600 min
Auto logon: Enabled
Auto logon user: User #7
AID delimiter: Yes
Enter new TL1/X.25 port data rate:
Session Timeout (0-1440, 0 = disable):
Auto logon (Y or N):
Auto logon user:
AID Delimiter (Y or N):
Save changes (Y or N):
Must issue a hardware reset for changes to take effect
TL1 (over Ethernet) Software Option Installed
Command<6>: SET MODE
TL1 Mode: Telnet
TCP Keepalive: Enabled
Port: 2020
Session Timeout: 600 min
Auto logon: Enabled
Auto logon user: User #7
AID delimiter: Yes
Enter new TL1 port number:
TCP Keepalive (Y or N): Y
Session Timeout (0-1440, 0 = disable):
Auto logon (Y or N):
Auto logon user:
To Next Page
Loading...
Need help?
General
