User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-247
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET VORTEX PASSWORD
Description: Sets the password issued by LMS1000 to gain remote access to the VPS.
This password must match the VPS's MCA remote access password. By default, the
password issued by LMS1000 and set in a VPS is VORTEX, in all capitol letters.
LMS1000 issues the password set here (or the default if not previously set) when
LMS1000 is initially powered up or during a reset. The VPS does not grant remote
access until the correct password is sent by LMS1000.
Command Level: 6
Syntax: SET VORTEX PASSWORD
SE V PA
Comments: The VPS's MCA remote access password is case sensitive, and is limited
to 6 characters.
Notes: This command does not change the VPS's MCA remote access password, only
the password issued by the LMS1000 to gain remote access.
Record the new password in a secure place. There is no way to view the password set in
the LMS1000.
Also, if the MCA's remote access password is ever changed, record the new password in
a secure place. The current MCA remote access password cannot be viewed remotely
from LMS1000. The password can be viewed locally, from the MCA's Interface Pad.
Refer to the VPS manual for a procedure.
If LMS1000 does not successfully connect with the VPS during power up or reset, the
following message is displayed when a user attempts VPS access via the LMS1000.
Vortex SMART/MCA communications error
Related Commands: none
Example:
Command<6>: SET V PASSWORD
Enter current MCA password:
Enter new password:
Re-enter new password:
New password accepted