User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-323
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
<cid>
The calling identifier (<cid>) parameter determines the new calling identifier which
replaces the current one. This parameter is the new PRIMARY PHONE attribute for the
specified user’s LMS1000 user configuration. It can either be the network address or the
phone number of the specified user. Invalid values received for this parameter return an
error response with the error code IDNV.
<uap>
The user access privilege (<uap>) parameter determines the new user access privilege
which replaces the current one. This parameter is the new ACCESS LEVEL attribute for
the specified user’s LMS1000 user configuration. The LMS1000 prohibits a user from
changing ones own access level. If the user being edited is the same as the session
user (i.e., user who is performing the edit) this parameter cannot be changed. If an
invalid value is entered or if the session user requests to change his own user privilege
code, then an error response is returned using the error code PIUC.
<keyword-defined block>
This parameter has no relevance in LMS1000, and is ignored if included.
LMS1000 Response Format Variations: None
To Next Page
Loading...
Need help?
General
