EasyManuals Logo

Emerson LMS1000 User Manual

Emerson LMS1000
485 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #425 background imageLoading...
Page #425 background image
User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-343
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
configuration. Invalid values for this parameter return an error response with the error
code IDNV.
<locn>
This parameter does not apply to LMS1000. The only valid value for this parameter is
NULL. Invalid values for this parameter return an error response with the error code
IDNV.
<dirn>
This parameter does not apply to LMS1000. The only valid value for this parameter is
NULL. Invalid values for this parameter return an error response with the error code
IDNV.
<tmper>
This parameter does not apply to LMS1000. The only valid value for this parameter is
NULL. Invalid values for this parameter return an error response with the error code
INUP.
LMS1000 Response Format Variations:
<aidtype>
Valid values for an access identifier type response parameter are:
EQPT equipment
COM common
<ntfcncde>
This is the notification code parameter associated with a single alarm condition given in
this block. Valid values are the same as for the input format. Values are derived from
the NOTIFICATION CODE attribute of the LMS1000 channel or limit configuration with
which the alarm condition is associated.
<condtype>
This is the condition type parameter associated with the alarm condition given in this
block. Valid values are the same as for the input format. Values are derived from the
NOTIFICATION CODE attribute of the LMS1000 channel or limit configuration with which
the alarm condition is associated.
<locn>, <dirn>, <tmper>
These parameters do not apply to LMS1000. A NULL value is inserted for them.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Emerson LMS1000 and is the answer not in the manual?

Emerson LMS1000 Specifications

General IconGeneral
BrandEmerson
ModelLMS1000
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals