Emerson LMS1000 User Manual

User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 2. Operating LMS1000 Page 2-23
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
44) "4 ch A/D <#n> EEPROM fail".
45) Rectifier sequencing is enabled, disabled, or configured.
46) Group <# n> configured.
47) Set limits of analog or function channel.
48) Set control program line of relay, LED, or function channel(s).
49) Number of rings before answer is set.
50) Alarm class <#n> is configured.
51) Local communications port data rate is set.
52) User mail is set.
53) System alarm report parameters are configured.
54) I/O card <#n> added.
55) Search for new nodes (“NODE ADD” command).
56) Node <#n> configured.
57) Node <#n> or unmapped node deleted.
58) Node <#n> replaced.
59) I/O Network initialized.
60) Upload abort before completion (partial upload).
61) Upload of TL1 parameters failed.
62) TL1 operating mode is configured.
63) TL1 AID <#n> is configured.
64) Channel database configured.
65) One of the following IP (internet) parameter address was changed: Unit address,
Gateway address, Netmask address, Host address added, Host address deleted.
66) SNMP operation was enabled or disabled.
67) SNMP “GET” or “SET” community string was changed.
68) SNMP traps operation enabled, disabled, or version changed.
69) SNMP traps host added or deleted.
70) SNMP occurred, retired, or persistent traps enabled or disabled.
71) Execution of the following TL1 commands results in an event log entry: ALW-
MSG, INH-MSG, OPR-EXT-CONT, RLS-EXT-CONT, INIT-SYS, DEL-USER,
EDIT-PID, EDIT-USER, ENT-USER, SET-ATTR.
72) Main chassis channel initialization failed.
73) Power Metering Statistics cleared.
74) Application Vx.x.x.x changed.
75) HTTP create socket failed.
76) HTTP task reset.
77) HTTP bind socket failed.
78) HTML checksum failure.
79) VI parameters set.
80) Battery Discharge Timer set.
81) Key code nn validated
82) Invalid Key Code Entered
VPS MCA Events: The following actions performed at the VPS's MCA local interface
pad or event (#28 below) are recorded in the events log.
1) System float voltage set
2) System test/equalize voltage set
3) System high voltage shutdown set
4) System current limit set
5) System output voltage calibration reading set
6) NAG (audible alarm cutoff reset time period) minutes set
7) Battery charge temperature compensation module's calibration voltage set
8) System high voltage alarm #1 set
9) System high voltage alarm #2 set
10) System 50% battery on discharge alarm set

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English