Emerson LMS1000 User Manual

User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-357
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
This parameter does not apply to LMS1000. The only valid value for this parameter is
NULL. Invalid values received for this parameter return an error response with the error
code IDNV.
LMS1000 Response Format Variations: If no threshold can be found which matches
the input parameters, an error response with the error code IDNV is returned.
<aid>
The access identifier parameter identifies the single equipment unit for which a threshold
is being retrieved.
<aidtype>
Valid values for an access identifier type response parameter are:
EQPTequipment
<montype>
This is the monitor type parameter of the threshold given in this block. Values are
derived from the MONITOR TYPE attribute of the LMS1000 analog or function channel
configuration. This parameter contains a suffix to designate the type of threshold being
retrieved. The suffix is separated from the monitor type parameter by a hyphen, and
takes the form LT or HT to indicate low or high threshold types, respectively.
Example: DCVOLT-LT
<locn>
This is the location of the threshold being retrieved. This parameter specifies the
threshold number (alarm limit number) of the specified analog or function channel. Valid
values for this parameter are LILMS1000-x, where x is a positive integer from one
through four, which specifies the threshold number of the channel with which the
threshold is associated.
<dirn>
This parameter does not apply to LMS1000. The value of this parameter is returned as a
NULL value.
<thlev>
This is the current threshold level for the monitored parameter. Valid data types for the
threshold level for a given monitor type are the same as for the corresponding monitor
type parameter (e.g., for the channel with which the threshold is associated).
<tmper>
This parameter does not apply in LMS1000. A NULL value is inserted for this parameter.

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English