Device Functions Proline Promass 83 FOUNDATION Fieldbus 3 Transducer Block
Endress+Hauser 177
Tube Damping -
Warning Level
AUTO - OOS
! Note!
This option is not active unless ON was selected in the parameter
"Adv. - Warning Mode".
Use this parameter to specify a limit value for tube damping. A notice
message is generated if the limit value is exceeded.
User input:
0 to 99999 [%]
Factory setting:
1000%
El.Dyn.Sens. -
Ref.Value Factory
read only The reference value for the electrodynamic sensors appears on the display.
Display:
5-digit floating-point number
El.Dyn.Sens. -
Ref.Value User
read only The reference value for the electrodynamic sensors appears on the display.
Display:
5-digit floating-point number
El.Dyn.Sens. -
Actual Value
read only The measuring values for the electrodynamic sensors appear on the display.
Display:
5-digit floating-point number
El.Dyn.Sens. -
Min. Value
read only The lowest value of the electrodynamic sensors since the saved values were
last reset appears on the display.
Display:
5-digit floating-point number
El.Dyn.Sens. -
Max.Value
read only The highest value of the electrodynamic sensors since the saved values were
last reset appears on the display.
Display:
5-digit floating-point number
El.Dyn.Sens. -
History 1…10
read only The last ten values of the electrodynamic sensors since the saved values
were last reset appear on the display.
Display:
5-digit floating-point number
El.Dyn.Sens. -
Deviation
read only This function displays the deviation between the measured values for the
electrodynamic sensors and the reference values selected in the parameter
"Adv. - Select Ref.Condition" (FACTORY or USER) → Page 170.
Display:
5-digit floating-point number
"Advanced Diagnostics" Transducer Block/base index 2200
Parameter
Write access
with operating
mode
(MODE_BLK)
Description
To Next Page
Loading...
