Wireless Network Projection
136
a
Press the [Menu] button, select the Management menu, and press
[Enter].
b
Set the Wireless LAN Power setting to On.
c
Select the Network menu and press [Enter].
d
Select Network Settings and press [Enter].
e
To identify the projector over the network, select Projector Name and
enter a name up to 16 alphanumeric characters long.
f
Set the Priority Control Interface setting to Wireless LAN.
g
Select the connection method.
• For simple AP mode, set the Simple AP setting to On and go to step
12.
• For infrastructure mode, set the Simple AP setting to Off and go to
next step.
• If you installed the optional wireless LAN module and want to use
both connection methods at the same time, set the Simple AP setting
to On and go to next step
To Next Page
Loading...
Need help?
General
