Displaying a Test Pattern
55
You can display a test pattern to adjust the projected image without
connecting a computer or video device.
a
• The test pattern's shape is determined by the Screen Type setting. Be
sure to set the correct screen type before adjusting with the test
pattern.
• To set menu items that cannot be set while the test pattern is being
displayed or to fine-tune the projected image, project an image from
the connected device.
a
Turn on the projector.
b
Press the down arrow button on the control panel.
A test pattern is displayed.
a
You can also display a test pattern from the projector's
Installation menu.
c
Press the left or right arrow button on the remote control, or press
[Enter] on the control panel to cycle through the available test patterns.
d
Adjust the image as necessary.
e
To remove the test pattern, press [Esc].
To Next Page
Loading...
Need help?
General
