Projector Network Settings - Network Menu
199
Setting Options Description
DNS Server 1
DNS Server 2
Various IP
addresses
Enter the IP address for the DNS server,
using 0 to 255 for each address field. The
DNS server resolves the host name. Do
not use the following IP addresses:
127.x.x.x (where x is a number from 0 to
255).
When these settings are not set and
remain as 0.0.0.0, DNS server
information is acquired using DHCP.
After acquiring the information, the
values remain as 0.0.0.0.
IPv6 On
Off
Set to On if you want to connect the
projector to the network using IPv6.
IPv6 is supported to monitor and control
the projector over a network using Epson
Web Control and PJLink.
Auto Configuration On
Off
Set to On to assign addresses
automatically according to the Router
Advertisement.
Use Temporary
Address
On
Off
Set to On if you want to use a temporary
IPv6 address.
IP Address Display On
Off
Set to On to display the IP address on the
network information screen and Home
screen.
Network Menu - Wired LAN Menu
Settings on the Wired LAN menu let you select the wired LAN settings.
Setting Options Description
IP Settings DHCP
IP Address
Subnet Mask
Gateway Address
Set DHCP to On if your network assigns
addresses automatically; set to Off to
manually enter the network's IP
Address, Subnet Mask, and Gateway
Address using 0 to 255 for each address
field.
Do not use these addresses: 0.0.0.0,
127.x.x.x, 192.0.2.x or 224.0.0.0 through
255.255.255.255 (where x is a number
from 0 to 255) for IP Address,
255.255.255.255 or 0.0.0.0 through
254.255.255.255 for Subnet Mask, and
0.0.0.0, 127.x.x.x or 224.0.0.0 through
255.255.255.255 for Gateway Address.
DNS Server 1
DNS Server 2
Various IP
addresses
Enter the IP address for the DNS server,
using 0 to 255 for each address field. The
DNS server resolves the host name. You
cannot use the following IP addresses:
127.x.x.x (where x is a number from 0 to
255).
When these settings are not set and
remain as 0.0.0.0, DNS server
information is acquired using DHCP.
After acquiring the information, the
values remain as 0.0.0.0.
IPv6 On
Off
Set to On if you want to connect the
projector to the network using IPv6.
IPv6 is supported to monitor and control
the projector over a network using Epson
Web Control and PJLink.
Auto Configuration On
Off
Set to On to assign addresses
automatically according to the Router
Advertisement.
Use Temporary
Address
On
Off
Set to On if you want to use a temporary
IPv6 address.
IP Address Display On
Off
Set to On to display the IP address on the
network information screen and Home
screen.
To Next Page
Loading...
Need help?
General
