Setting Up Projector Network E-Mail Alerts
168
You can set up the projector to send you an e-mail alert over the network if
there is a problem with the projector.
If you set the Standby Mode setting to Communication On in the projector's
Operation menu, you can receive the e-mail alerts even if the projector is in
standby mode (when the power is off).
a
Press the [Menu] button, select the Network menu, and press [Enter].
b
Select Network Settings and press [Enter].
c
Select the Mail Notification menu and press [Enter].
d
Set the Mail Notification setting to On.
e
Enter the IP address for the SMTP Server option.
a
Do not use "127.x.x.x" (where x is a number from 0 to 255) for
the SMTP Server.
f
Select a type of Authentication of SMTP server.
g
Select a number for the SMTP server Port Number, from 0 to 65535
(default is 25).
h
Enter a User Name for the SMTP server.
i
Enter a Password for the SMTP server authentication.
j
Enter the e-mail address to be indicated as the sender in From.
k
Choose an address field, enter the e-mail address, and select the alerts
you want to receive. Repeat for up to three addresses.
a
Your e-mail address can be up to 64 alphanumeric characters
long.
l
When you finish selecting settings, go back to the Network Settings
screen, select Set, and follow the on-screen instructions to save your
settings and exit the menus.
a
If a critical problem causes a projector to shut down, you may not
receive an e-mail alert.
gg Related Links
• "Network Projector E-mail Alert Messages" p.168
Network Projector E-mail Alert Messages
When a problem occurs with a projector on the network, and you selected to
receive e-mail alerts, you receive an e-mail containing the following
information:
• The email address set in From as the mail sender
• Epson Projector in the subject line
• The name of the projector experiencing a problem
• The IP address of the affected projector
• Detailed information about the problem
To Next Page
Loading...
Need help?
General
