Solving Network Problems
239
Solutions When the Image or Sound Contains Static
During Screen Mirroring Connection
If the projected image or sound contains static when connecting using Screen
Mirroring, try the following solutions:
• Avoid covering the Wi-Fi antenna of the mobile device.
• If you use a Screen Mirroring connection and an internet connection at the
same time, the image may stop or contain noise. Disconnect the internet
connection to expand your wireless bandwidth and improve the connection
speed of the mobile device.
• Make sure the projection contents meet the Screen Mirroring requirements.
• Depending on the settings of the mobile device, the connection may be lost
when the device enters power saving mode. Check the electrical power
saving settings on the mobile device.
• Update to the latest version of the wireless driver or firmware on the mobile
device.
Solutions When You Cannot Receive Shared Images
If you cannot receive shared images from other projectors, try the following
solutions:
• Connect the projector to the same network as the projector that is sharing
images.
• Make sure the Screen Sharing setting is set to On.
s Network > Network Settings > Network Projection > Screen Sharing
• Make sure that no other device is connecting to the projector using the
Epson iProjection software.
• If the firmware version amongst the projectors sharing the screen is not the
same, you may need to update the projector's firmware to share your screen.
gg Related Links
• "Network Menu - Network Projection Settings" p.201
To Next Page
Loading...
Need help?
General
