Solving Network Problems
238
• Set the Standby Mode setting to Communication On in the projector's
Operation menu so that the network software can monitor the projector in
standby mode.
Change the Port setting according to your network environment. If you are
connecting wirelessly, connect to devices over a wireless network access
point.
gg Related Links
• "Network Menu - Mail Notification Menu" p.200
• "Projector Feature Settings - Operation Menu" p.189
Solutions When the Image Contains Static During
Network Projection
If the projected image contains static during network projection, try the
following solutions:
• Check for any obstacles between the access point, the computer, the mobile
device, and the projector, and change their positions to improve
communication.
• Make sure that the access point, the computer, the mobile device and the
projector are not too far apart. Move them closer together and try to
connect again.
• Check for interference from other equipment, such as a Bluetooth device or
microwave. Move the interfering device farther away or expand your
wireless bandwidth.
• Reduce the number of connected devices if the connection speed declines.
Solutions When You Cannot Connect Using Screen
Mirroring
If you are unable to connect to the projector using Screen Mirroring, try the
following solutions:
• Check the projector's settings.
• Set the Simple AP setting to On.
s Network > Network Settings > Simple AP
• Set the Screen Mirroring setting to On.
s Network > Network Settings > Network Projection > Screen
Mirroring
• Select the Screen Mirroring setting to Off and select On again.
s Network > Network Settings > Network Projection > Screen
Mirroring
• Check the mobile device's settings.
• Make sure the settings on the mobile device are correct.
• When connecting again immediately after disconnecting, it may take
some time until the connection is established. Reconnect after waiting for
a while.
• Restart the mobile device.
• Once you have connected using Screen Mirroring, the projector
connection information may be recorded on the mobile device. However,
you may not be able to reconnect to the projector from the recorded
information. Select the projector from the list of available devices.
gg Related Links
• "Network Menu - Network Settings Menu" p.196
• "Network Menu - Network Projection Settings" p.201
Solutions When You Cannot Use Two Screen
Mirroring Sources
If you are unable to use two Screen Mirroring sources at the same time, set
the Interrupt Connection setting to Off.
s Network > Network Settings > Network Projection > Screen Mirroring
gg Related Links
• "Network Menu - Network Projection Settings" p.201
To Next Page
Loading...
Need help?
General
