Solving Projector or Remote Control Operation Problems
236
• Press the 0 (zero) button on the remote control while holding down the
[ID] button. By selecting 0 on the remote control, you can operate all of the
projectors regardless of the projector ID settings.
• If you lose the remote control, you can order another one from Epson.
gg Related Links
• "Remote Control Operation" p.40
• "Projector Installation Settings - Installation Menu" p.185
• "Installing Batteries in the Remote Control" p.39
• "Selecting the Projector You want to Operate" p.114
Solutions to Password Problems
If you cannot enter or remember a password, try the following solutions:
• You may have turned on password protection without first setting a
password. Try entering 0000 using the remote control.
• If you have entered an incorrect password too many times and see a
message displaying a request code, write down the code and contact Epson
for help. Provide the request code and proof of ownership for assistance in
unlocking the projector.
• If you set an Epson Web Control password and forgot the user ID or
password, try entering the following:
• User ID: EPSONWEB
• Default password: admin
• If you set a Remote password (in Epson Web Control) and forgot the user
ID or password, try entering the following:
• User ID: EPSONREMOTE
• Default password: guest
• If you lose the remote control you cannot enter a password. Order a new
one from Epson.
Solution When "The Battery that Saves Your Clock
Settings is Running Low" Message Appears
If the message "The battery that saves your clock settings is running low." is
displayed, contact Epson for help.
To Next Page
Loading...
Need help?
General
