Turning Off the Projector
44
Turn off the projector after use.
a
• Turn off this product when it is not in use to prolong the life of the
projector. Light source life varies depending on the mode selected,
environmental conditions, and usage. Brightness decreases over time.
• If the Light Source Calibration setting is set to Run Periodically in
the projector's Management menu, light source calibration starts
automatically if you turn off the projector and the following
conditions are present:
• 100 hours have passed since the last light source calibration
• You have used the projector continuously for more than 20
minutes
• Since the projector supports the direct shutdown feature, it can be
turned off directly using the breaker.
a
Press the power button on the control panel or remote control.
The projector displays a shutdown confirmation screen.
b
Press the power button again. (To leave it on, press any other button.)
The projector beeps twice, the light source turns off, and the status
indicator turns off.
c
To transport or store the projector, make sure the power indicator is
blue (but not flashing) and the status indicator is off, then unplug the
power cord.
d
Attach the lens cover.
To Next Page
Loading...
Need help?
General
