Projector Network Settings - Network Menu
198
Setting Options Description
WPA3-PSK Connects in WPA3 personal mode.
Communication is performed using
WPA3 security. Uses AES method for
encryption. When establishing a
connection from a computer to the
projector, enter the value set in the
passphrase.
WPA3-EAP Connects in WPA3 enterprise mode.
Encryption method is selected
automatically according to the access
point settings.
Open Security is not set.
Passphrase
(For
WPA2/WPA3-PSK
and WPA3-PSK
security)
Various
passphrases from 8
to 63 characters
Enter the pre-shared passphrase used on
the network.
When the passphrase is entered and the
[Enter] button is pressed, the value is set
and displayed as an asterisk (*).
We recommend changing the passphrase
periodically for security. If the network
settings are initialized, it returns to the
initial passphrase.
EAP Type
(For
WPA2/WPA3-EAP
and WPA3-EAP
security)
PEAP Authentication protocol widely used in
Windows Server.
PEAP-TLS Authentication protocol used in
Windows Server. Select this when using a
client certificate.
EAP-TLS Authentication protocol widely used to
use a client certificate.
EAP-FAST Select this when these authentication
protocols are used.
Setting Options Description
User name Up to 64
alphanumeric
characters
Enter a user name for the network. To
include a domain name, add it before a
backslash and the user name
(domain\username).
When importing a client certificate, the
name the certificate was issued to is
automatically set.
Password Up to 64
alphanumeric
characters
Enter a password for authentication.
After you enter the password and select
Set, the password is displayed as an
asterisk (*).
Setting is only displayed when EAP Type
is set to PEAP or EAP-FAST.
Client Certificate — Imports the client certificate.
Setting is only displayed when EAP Type
is set to PEAP-TLS or EAP-TLS.
Verify Server
Certificate
On
Off
Set to On to verify the server certificate
when a CA certificate has been set.
CA certificate — Imports the CA certificate.
RADIUS Server
Name
Up to 64
alphanumeric
characters
Enter the server name to verify.
IP Settings DHCP
IP Address
Subnet Mask
Gateway Address
Set DHCP to On if your network assigns
addresses automatically; set to Off to
manually enter the network's IP
Address, Subnet Mask, and Gateway
Address using 0 to 255 for each address
field.
Do not use these addresses: 0.0.0.0,
127.x.x.x, 192.0.2.x or 224.0.0.0 through
255.255.255.255 (where x is a number
from 0 to 255) for IP Address,
255.255.255.255 or 0.0.0.0 through
254.255.255.255 for Subnet Mask, and
0.0.0.0, 127.x.x.x or 224.0.0.0 through
255.255.255.255 for Gateway Address.
To Next Page
Loading...
Need help?
General
