INSTALLATION
Mechanical mounting
Mount the modules of the MSC system on a 35-mm DIN rail as follows:
1. Connect together a number of rear 5-pin MSCB plug connectors to suit the
number of modules to be installed.
2. Mount the row of plug connectors assembled in this manner on the DIN rail
(first hook on at the top).
3. Mount modules on the rail and during this process place the contacts on
the base of the module over the related plug connector. Carefully push in
module until it noticeably engages.
4. To remove the module, the catch on the rear of the module must be pulled
down with the aid a screwdriver and the module lifted and pull off upward.
1 2a
2b 3 4
Figure 1
To Next Page
Loading...
