CHAPTER 27
PAGE 11
PAGE DATE: 1. March 2011
MAINTENANCE MANUAL EXTRA 330LX
27-00-04 Rear Control Stick
Removal/Installation
1 Remove rear seat as per chapter 25-10-02.
2 Disconnect the electrical wiring.
3 Bring the control stick in the foremost position and discon-
nect the control stick from the control rods per chapter 27-
00-01.
4 Remove the control stick attachment bolt.
5 Remove the control stick.
6 Reverse procedure to install the control stick. Replace the
selflocking nuts. Observe the first note of chapter 27-00-
00.
7 Inspect for potential chafing of the wiring after installation.
27-00-05 Torque Tube
Removal/Installation
1 Remove the bottom fuselage cover as per chapter 51.
2 Remove the control sticks and rods as per chapters 27-00-
01 and 27-00-03/04.
3 Loosen the bolts of the front and rear bearing blocks.
4 Disassemble the bearing blocks and remove the torque tube.
5 Reverse procedure to install the torque tube. Ensure that
the lubrication hole of the rear bearing block is on the bot-
tom. Lubricate the rear bearing with MIL-G-81322D grease
(Aeroshell grease 22C or equivalent).
To Next Page
Loading...
