CHAPTER 79
PAGE 11
MAINTENANCE MANUAL EXTRA 330LX
PAGE DATE: 1. March 2011
79-30-13 Engine Fitting
Removal/Installation
1 Remove upper cowling per Chapter 71.
2 Disconnect the sense wet line per Chapter 79-30-12.
3 Remove the engine fitting.
4 Install in reverse sequence of removal. Torque engine fit-
ting with 15.3 to 16.9Nm (135 to 150 in.lbs.) and apply in-
spection lacquer.
79-30-20 Oil Temperature
The oil temperature gauge is located in the rear instrument
panel. The gauge receives its data electrically from a sensor
located on the engine in front of the oil filter screen (refer
to figure 5).
79-30-21 Oil Temperature Gauge
Oil temperature indication is combined with the oil pressure
indication in a single unit.
79-30-22 Oil Temperature Sensor
Removal/Installation
The sensor can be easily removed and installed without
special equipment.
1 Remove upper cowling per Chapter 71.
2 Remove oil temperature sensor (refer to figure 5).
3 Install in reverse sequence of removal.
To Next Page
Loading...
