CHAPTER 73
PAGE 8
MAINTENANCE MANUAL EXTRA 330LX
PAGE DATE: 14. August 2015
4 If necessary adjust rod ends (2, figure 4; 6, figure 3) to en-
sure correct over-travel by the following steps:
a Remove cotter pin, castle nut, washers and bolt of the rod
end from throttle lever (1, figure 4) and rear throttle control
lever (6, figure 3).
b Loosen the counter nut at rod ends and adjust travel positions
and over travel by turning related rod end(s). Ensure thread
is visible in the inspection hole when fastening. Apply
inspection lacquer on the counter nut.
c Reconnect the rod ends.
73-20-13 Front Throttle Control Lever
Removal/Installation
1 Ensure master switch is off.
2 Remove engine cowling per chapter 71.
3 Remove main fuselage cover per chapter 53.
4 Disconnect the throttle control linkage (3, figure 3) from
the front throttle control lever (1).
5 Disconnect the throttle control handle (2) from the front
throttle control lever (1).
6 Disconnect throttle control lever attachment by removing
cotter pin, castle nut, washers and bolt (9) and remove throttle
control lever.
7 Install in reverse sequence of removal. Tighten the throttle
control lever castle nut (9) slightly. Ensure movability of
levers.
To Next Page
Loading...
