Extra 300LX - 55-30-00 VERTICAL STABILIZER

CHAPTER 55
PAGE 8
PAGE DATE: 1. March 2011
MAINTENANCE MANUAL EXTRA 330LX
55-30-00 VERTICAL STABILIZER
Removal
1 Remove the tail fairing and the tail cone access panel as per
chapter 51-00-01.
2 Remove the rudder as per chapter 27-20-01.
3 Remove the bottom hinge bracket assembly as per chapter
27-20-02.
4 Remove the two stop nuts (2, figure 4) and washers of the
front main bolts.
5 Remove the rear main bolt (3) with the washers and the stop
nut.
6 Move the fin backward and remove.
Installation
1 Position the vertical stabilizer over the aircraft tail.
2 Slide the auxiliary spar attachment sheet (1, figure 4) of the
vertical stabilizer from the rear over the preinstalled hori-
zontal stabilizer front spar bolts and install the washers and
stop nuts (2).
3 Insert the bolt (3) to the main spar from rear to front. Use
stop nuts and washers.
4 Install the bottom hinge bracket to the tail as per chapter
27-20-02.
5 Reinstall the tail fairing, the tail side skins and the tail cone
access panel as per chapter 51-00-01.