CHAPTER 27
PAGE 15
PAGE DATE: 17. March 2014
MAINTENANCE MANUAL EXTRA 330LX
2 Check length of the control rod (6) connecting the torque
tube and the inner wing bellcranks as per measurements table
in chapter 27-00-01.
3 Adjust length if necessary per Chapter 27-00-01.
4 Check if the ailerons are in 0°-position (The trailing edge
bottom of the aileron is in alignment with the trailing edge
bottom of the wing as shown in Figure 12).
5 If necessary adjust the length of the control rods connect-
ing the aileron actuator arm to the outer wing bellcrank per
chapter 27-00-01.
6 Check if the left aileron travel is within the given tolerances
(up 30°/down 30°, tol. ±2°). Use a conventional protractor.
7 Adjust the travel stops if necessary.
8 Follow step 6 for the right aileron.
Figure 12 Trailing Edge Alignment
9 If the travel of the right aileron exceeds the given toler-
ances, contact the manufacturer.
10 Check if the movement of the control sticks is free over the
whole travel range and check if the rear control stick travel
is symmetrically to each side. If it is not contact the manu-
facturer.
To Next Page
Loading...
