CHAPTER 51
PAGE 37
PAGE DATE: 1. March 2011
MAINTENANCE MANUAL EXTRA 330LX
5 Where applicable refer to inspection procedures given in
the respective chapters for specific parts to locate possible
defects.
N O T E Refinishing should be completed as soon as possible;
unprotected parts will begin to corrode.
Repainting
Paint all surfaces except those which are subjected to fric-
tion (bearing surfaces, anchor bolt bores, etc.). Proceed as
follows:
1 Parts to be repainted should be cleaned and stripped per in-
struction in degreasing and paint removal paragraphs.
2 Aluminium parts should have a protective barrier between
the topcoat and base metal. It is recommended they be treated
with solutions listed in chapter 51-30.
3 For priming follow the procedures given by the coating
manufacturers.
4 Paint parts with one coat of lacquer listed in chapter 51-30.
Allow to dry thoroughly before reassembly.
To Next Page
Loading...
