Extra 300LX - Page 76

CHAPTER 5
PAGE 38
PAGE DATE: 1. March 2011
MAINTENANCE MANUAL EXTRA 330LX
Inspector:
Mechanic:
Inspections
Date:
Serial No.:
Hard Landing
UNSCHEDULED MAINTENANCE CHECKS
Landing gear
O 1 Examine landing gear mounting clamps for defects (e.g. cracks and
deformed areas).
O 2 Check clamp bolts and anti abrasion strips of the landing gear for
cracks and wear, replace when necessary.
O 3 Examine wheel track and check if measurement corresponds to the
value given in chapter 06-10-01.
O 4 Remove and check the fairings for delamination, deformations and
cracks.
O 5 Check the landing gear spring for delamination, deformations and
cracks, especially in the area of the axle and spring to fuselage
attachment.
O 6 Check fuselage structure in the area of landing gear attachment for
deformation and cracks.
O 7 Examine wheel base and check if measurement corresponds to the
value given in chapter 06-10-01.
O 8 Check tires for cuts in the side wall.
O 9 Check wheel rim halves and brake discs for impacts, cracks and
distortion according to CLEVELAND instruction.
O 10 Check tail wheel and fork for deformation and cracks, especially in
the area of the axle attachment.
O 11 Check fuselage structure in the area of the tail wheel for deforma-
tion and cracks.
Control surfaces
O 12 Check control surfaces for proper operation.
O 13 If air tow hook is installed: Inspect rudder bottom rib for impact.
O 14 Check control surface hinges for cracks, security and free move-
ment.
O 15 Check the balance weights of the elevator for security of attach-
ment.
O 16 Check the spades for security of attachment.
Engine
O 1 Check engine mount.