FaroArm® Quantum
August 2017
103
Chapter 4: Probes
The digitized compensation points then calculate and the COMPENSATION
S
TATUS updates. If the probe passes, the current date and time is added to the
probe information. Click Save and Exit to complete the compensation.
You now have two probes to digitize your part. Use the Probe Management
command to switch between the standard ball probe and the FARO Laser Line
Probe.
NOTE: If you remove the FARO Laser Line Probe, you must re-calibrate it
again to guarantee the accuracy of the measurements.
For more information,
see “Probe Compensation” on page 59.
NOTE: You can view the details for all probe compensations by clicking
View All.
See “View Log” on page 74.
Figure 4-16 Laser Line Probe Compensation Results
Figure 4-17 Probe Compensation List
08m80e00_FaroArm_Quantum.book Page 103 Tuesday, August 22, 2017 11:03 AM
To Next Page
Loading...
Need help?
General