FaroArm® Quantum
August 2017
102
Chapter 4: Probes
4. Digitize the White area of the FARO Compensation Plate with the FARO
Laser Line Probe.
• Aim the laser line at the middle of the white surface.
• Move the FARO Laser Line Probe until the laser is closer than the
Near Range .
• Press and hold the green Front button and slowly move the FARO
Laser Line Probe beyond the Far Range
while pointing to the
center of the white surface.
• Press the red Back button.
08m80e00_FaroArm_Quantum.book Page 102 Tuesday, August 22, 2017 11:03 AM
To Next Page
Loading...
