Use the OTDR
OTDR Results
225
Tap the settings you want. You can scroll some columns to see
more settings. Table 8 on page 199 gives descriptions of the
settings.
Select the wavelengths to use for the test.
Tap CURRENT to see the settings the tester used for the last test.
The SAVE SETUP button lets you save your settings:
Active: The tester saves the settings in the active test setup,
and changes the active Test Type to Manual.
New: The tester saves the settings in a new Manual test setup
that is added to the project. The tester uses the Manual setup
until you save the results or exit the results screen then start a
test from the home screen. Then the tester uses the test setup
it had before you changed the OTDR settings.
If you save your settings in a New test setup:
The tester uses your settings until you save the results or exit
the results screen then start a test from the home screen.
Then the tester uses the test setup it had before you changed
the settings.
If you do not save your settings:
The tester uses your settings until you save the results or exit
the results screen then start a test from the home screen.
Then the tester uses the test setup it had before you changed
the settings.
Tap TEST or press to do a test with the settings you
selected.
The PROGRESS screen shows Manual OTDR when the tester
uses your settings.
Note
If you want to use your settings when you are
finished with this test, make sure you save them.
See item
.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
