Output Format
111
Copy
3
2 Sided Copying (Making 2 sided Copies)
This feature is the same as [2 Sided] in the [Basic Copying] tab.
For more information, refer to "2 Sided Copying (Making 2 sided Copies)" (P.111).
Finishing (Outputting by specifying finishing)
You can specify the copy output method. When Stapling is specified, each set of copies
can be stapled and then output. In addition, the output position of copies is offset
alternately to distinguish each set of copies. When the Offset Stacking Module is
installed, the output position of copies is offset alternately to distinguish each set of
copies.
1 Select [Copy Output/Stapling].
2 Select any item.
îš„Auto
Copies are output collated when Auto Document Feeder, 2 Sided Book Copy, [Blank
Separators + N Sets] or [No Separators + N Sets] of Transparencies, Booklet, Stapling,
Build Job, Sample Set and Document > 50 sheets are set.
îš„Collated Stapling/Punching
The machine can output sheets sorted into sets that are arranged in page order.
îš„Uncollated
The machine can output the specified number of copies and sort sheets by page.
îš„Staple Position
You can set the position for stapling. If you select [More...], displays [Copy Output _
Stapling] screen.
For more information, refer to "[Copy Output - Stapling] Screen" (P.112).
Note • The number of pages that can be stapled is 2 to 100 (P paper). Plain paper, recycled paper,
lightweight paper, heavyweight paper 1, side 2 paper, punched paper, tab paper 1, and
custom paper 1 to 5 can be stapled.
• Depending on the type of paper that is being stapled, the stapled nails may be bent.
îš„Punch Position
You can set the position for punching. If you select [More...], displays [Copy Output -
Hole Punching] screen.
For more information, refer to "[Copy Output - Hole Punching] Screen" (P.113).
îš„Original Orientation
Refer to "Original Orientation (Specify the Orientation of Loaded Documents)" (P.88).
To Next Page
Loading...
Need help?
General
