Network Settings
341
Setups
10
Remote Authentication Server 1 through 5
Makes the remote authentication server settings.
îš„Server - Server Setup
You can select the remote authentication server specification method from [By IP
Address] and [By Server name].
îš„Server - IP Address
You can set the IP address of the remote authentication server using the values from
0 to 255.
Note • You can set a server IP address when [Server - Server Setup] is set to [By IP Address].
• 244.XXX.XXX.XXX to 255.XXX.XXX.XXX and 127.XXX.XXX.XXX cannot be set.
îš„Server - Server Name
You can set the name of the remote authentication server. Up to 255 characters can
be entered.
Note • You can set a server name when [Remote - Server Setup] is set to [By Server Name].
îš„Server - Port Number
You can set the port number of the remote authentication server either as 88 or within
the range of 1 to 65535.
îš„Server - Realm Name
Set the domain name of Active Directory to the realm name when you use Active
Directory of Windows 2000 Server and Windows Server 2003 as the remote
authentication server. Up to 64 characters can be entered.
Important • A realm name must be entered in capital letters. If the name is entered in lower-case letters,
an authentication error occurs.
PKI Settings (Public Key Infrastructure)
Set the HTTP-SSL/TLSand S/MIME.
1 Select [PKI Settings (Public Key
Infrastructure].
2 Select [HTTP-SSL/TLS Settings].
To Next Page
Loading...
Need help?
General
