Basic Copying
67
Copy
3
When [Calculator %] is Selected
You can specify a different size for the height and width.
If you specify both the document size and the copy size, the copy ratios for the height
and width are calculated automatically according to the sizes that you entered. The
calculation results are indicated by copy ratios within the range from 25 to 400%.
1 Select [Calculator %].
2 Enter the value for the document
width in [Original Size] of [X] (width)
using the numeric keypad, and
select [Next].
3 Enter the value for the copy size
width in [Copy Size] of [X] (width)
using the numeric keypad, and
select [Next].
4 In the same way, enter the
document height value and copy
size height value in the [Original
Size] and [Copy Size] of [Y]
(height), and select [Next].
Note • To change the copy ratios you have entered, select [Next], move [ ], and enter the
numerical values again.
îš„X (width) Y (height)
The automatically calculated ratio results may be displayed depending on the values
entered in [Original Size] and [Copy Size].
îš„Original Size
Set the height and width of the document size from 1 to 999 mm in 1 mm increments.
îš„Copy Size
Set the height and width of the copy size from 1 to 999 mm in 1 mm increments.
Paper Supply (Selecting the Paper to Use for Copying)
You can select the tray loaded with the copy paper you wish to use for copying.
Select the paper tray.
îš„Auto
Based on the document size and set ratios, the machine automatically selects the tray
loaded with the appropriate paper and makes copies.
Note • If you select [Auto], specify a value other than [Auto] for Reduce/Enlarge.
To Next Page
Loading...
Need help?
General
