3 Copy
66
Copy
3
When [Variable %] is Selected
You can enter any ratio for copying. Set the ratio within the range from 25 to 400% in
1% increments.
1 Select [Variable %].
2 Specify the ratio with the numeric
keypad or [ ] and [ ].
If you enter an incorrect value,
select [C].
When [Independent X-Y%] is Selected
You can specify different height and width ratios to scale the height and width
independently.
1 Select [Independent X-Y%].
2 To specify the height and width
ratios, use [ ] and [ ].
îš„Auto
Copies are made with the height and width ratios set automatically to match the paper
size. If this option is selected, a check mark is added.
îš„Auto (Copy All)
The height and width ratios are set automatically to match the paper size and the
document is copied at a slightly reduced size to prevent image loss. If this option is
selected, a check mark is added.
Important • If you select [Copy All], you need to set border erase dimensions to 0mm depending on the
size of the document. If the border erase documents is set to 0mm, the edge of the copied
document sometimes gets dirty or the image loss sometimes occurs depending of the size of
the documents.
îš„X (width) Y (height)
Set the height and width ratios within the range from 25 to 400% in 1% increments.
îš„XY
You can simultaneously change the numerical values of the height and width by the
same amount.
To Next Page
Loading...
Need help?
General
