Loading Paper
273
Paper and Other Media
9
Loading Paper in Tray 5 (Bypass)
When printing or copying with paper that does not match the sizes or types in trays 1
to 4 and the optional trays 6 to 7, use tray 5 (bypass). Following describes how to load
paper into tray 5 (bypass).
To make detailed instructions during printings, specify the instructions using the [Tray/
Output] tab in the print driver. When doing this, also specify the type of paper to load.
Note • When adding paper to tray 5 (bypass), remove any paper remaining in the tray, add it to the
bunch of papers to be added, then load all of the paper into the tray at once.
1 Open tray 5 (bypass) as necessary.
Note • If necessary, extend the
extension flap. The extension
flap can be extended in two
stages. When pulling out the
extension flap, do it gently.
2 Hold the center of the paper guides
and slide them to the desired paper
size.
3 Load paper with the side to be
copied or printed on facing up, and
insert the paper lightly along the
paper guide on the front side of the
machine until it comes to a stop.
Important • Do not load mixed size paper
into the tray.
• Do not load paper exceeding
the maximum fill line. Doing so
might cause paper jams or
machine trouble.
4 When loading a non-standard paper size from tray 5 (bypass), move the paper guides
to accommodate the paper.
5 Select copying or printing.
To Next Page
Loading...
Need help?
General
