4.7 Using the Network Settings Menus
fi-6010N Network Scanner Operator's Guide 115
4
6. Enter the button name.
The characters input here are displayed on the button name on the [LDAP List] tab.
This may be up to 18 characters long. Only alphanumeric characters may be entered.
A space (only one) also can be used, but the space will be displayed as a line break on the
button. Please note that a space between words cannot be made within a line. Only one blank
space can be entered.
7. Press the [OK] button.
The LDAP search parameters are set.
If the button names are changed, check the actual button image
shown on the LDAP "e-Mail Address Book" screen.
The button image may not show all characters entered.
To Next Page
Loading...
