8.3 Network Connection Troubleshooting
fi-6010N Network Scanner Operator's Guide 459
8
■ Checking the NTP server settings by synchronizing the system
time
On the "NTP Server" screen, press the [Sync Time] button to check if the system time can be syn-
chronized.
After pressing the [Sync Time] button, follow each action described below according to the mes-
sage that is shown.
Message Action
System time has been suc-
cessfully synchronized.
None
System time synchronization
failed.
Try the following:
z Check the specified NTP server IP address, host name, or
FQDN for mistakes, and correct them.
z Check the network path between to the NTP server for
problems.
z The NTP server may be busy. Wait a short time before try-
ing again to synchronize the system time. If that does not
work, the specified server may not be an NTP server, so
try a different NTP server.
z The specified NTP server cannot provide a trusted date
and time. It attempted to acquire the date and time from a
higher level NTP server, but failed. Try a different NTP
server or have the network administrator investigate.
z Check that the time is correct.
If the time is incorrect, adjust the date/time, and try again.
z Refer to "4.6.5 Setting the Date/Time" (page 64), adjust
the date/time, and try again.
To Next Page
Loading...
